What are two advantages of static routing over dynamic routing? (Choose two.)

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q2

What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?

What is the correct syntax of a floating static route?

What is a characteristic of a static route that matches all packets?

 What type of route allows a router to forward packets even though its routing table contains no specific route to the destination network?

Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?

A company has several networks with the following IP address requirements:
IP phones – 50
PCs – 70
IP cameras – 10
wireless access points – 10
network printers – 10
network scanners – 2

Which block of addresses would be the minimum to accommodate all of these devices if each type of device was on its own network?

 What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state?

The network administrator configures the router with the ip route 172.16.1.0 255.255.255.0 172.16.2.2 command. How will this route appear in the routing table?

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q10

What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)

Which type of static route that is configured on a router uses only the exit interface?

Refer to the graphic.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q12

Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q13

The network administrator needs to configure a default route on the Border router. Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?

What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.)

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q15

What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q16

Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?

Consider the following command:

ip route 192.168.10.0 255.255.255.0 10.10.10.2 5

Which route would have to go down in order for this static route to appear in the routing table?

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q18

The routing table for R2 is as follows:

Gateway of last resort is not set

10.0.0.0/30 is subnetted, 2 subnets
C 10.0.0.0 is directly connected, Serial0/0/0
C 10.0.0.4 is directly connected, Serial0/0/1
192.168.10.0/26 is subnetted, 3 subnets
S 192.168.10.0 is directly connected, Serial0/0/0
C 192.168.10.64 is directly connected, FastEthernet0/0
S 192.168.10.128 [1/0] via 10.0.0.6

What will router R2 do with a packet destined for 192.168.10.129?

A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?

 Consider the following command:

ip route 192.168.10.0 255.255.255.0 10.10.10.2 5

How would an administrator test this configuration?

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q21

The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue?

Which three IOS troubleshooting commands can help to isolate problems with a static route? (Choose three.)

An administrator issues the ipv6 route 2001:db8:acad:1::/32 gigabitethernet0/0 2001:db8:acad:6::1 100 command on a router. What administrative distance is assigned to this route?

Refer to the exhibit.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q24

The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?

Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.

Why are the pings from PC0 to Server0 not successful?

Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.

CCNA 2 v6.0 RSE Chapter 2 Exam Answers q26

What IPv6 static route can be configured on router R1 to make a fully converged network?