CCNA 2 v6.0 Routing and Switching Essentials RSE Final B Exam Online
CCNA 2 v6.0 RSE Final B Exam Training |
|
---|---|
Time | 60 minutes |
Questions | 50 |
Time limit: 0
Quiz-summary
0 of 50 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- 40
- 41
- 42
- 43
- 44
- 45
- 46
- 47
- 48
- 49
- 50
Information
CCNA 2 v6.0 Final Exam B
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 50 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
Your result has been entered into leaderboard
Loading
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- 40
- 41
- 42
- 43
- 44
- 45
- 46
- 47
- 48
- 49
- 50
- Answered
- Review
-
Question 1 of 50
1. Question
1 pointsRefer to the exhibit. Host A has sent a packet to host B. What will be the source MAC and IP addresses on the packet when it arrives at host B?
Correct
Incorrect
-
Question 2 of 50
2. Question
1 pointsWhat is the effect of configuring the ipv6 unicast-routing command on a router?
Correct
Incorrect
-
Question 3 of 50
3. Question
1 pointsWhat is a characteristic of a static route that creates a gateway of last resort?
Correct
Incorrect
-
Question 4 of 50
4. Question
1 pointsRefer to the exhibit. Which route was configured as a static route to a specific network using the next-hop address?
Correct
Incorrect
-
Question 5 of 50
5. Question
1 pointsRefer to the exhibit. Which command will properly configure an IPv6 static route on R2 that will allow traffic from PC2 to reach PC1 without any recursive lookups by router R2?
Correct
Incorrect
-
Question 6 of 50
6. Question
1 pointsA router has used the OSPF protocol to learn a route to the 172.16.32.0/19 network. Which command will implement a backup floating static route to this network?
Correct
Incorrect
-
Question 7 of 50
7. Question
1 pointsRefer to the exhibit. An administrator is attempting to install an IPv6 static route on router R1 to reach the network attached to router R2. After the static route command is entered, connectivity to the network is still failing. What error has been made in the static route configuration?
Correct
Incorrect
-
Question 8 of 50
8. Question
1 pointsWhich statement describes a route that has been learned dynamically?
Correct
Incorrect
-
Question 9 of 50
9. Question
2 pointsCompared with dynamic routes, what are two advantages of using static routes on a router? (Choose two.)
Correct
Incorrect
-
Question 10 of 50
10. Question
1 pointsTo enable RIP routing for a specific subnet, the configuration command network 172.16.64.32 was entered by the network administrator. What address, if any, appears in the running configuration file to identify this network?
Correct
Incorrect
-
Question 11 of 50
11. Question
1 pointsRefer to the exhibit. What is the administrative distance value that indicates the route for R2 to reach the 10.10.0.0/16 network?
Correct
Incorrect
-
Question 12 of 50
12. Question
1 pointsWhich route will a router use to forward an IPv4 packet after examining its routing table for the best match with the destination address?
Correct
Incorrect
-
Question 13 of 50
13. Question
2 pointsWhich two factors are important when deciding which interior gateway routing protocol to use? (Choose two.)
Correct
Incorrect
-
Question 14 of 50
14. Question
1 pointsEmployees of a company connect their wireless laptop computers to the enterprise LAN via wireless access points that are cabled to the Ethernet ports of switches. At which layer of the three-layer hierarchical network design model do these switches operate?
Correct
Incorrect
-
Question 15 of 50
15. Question
1 pointsWhich network design may be recommended for a small campus site that consists of a single building with a few users?
Correct
Incorrect
-
Question 16 of 50
16. Question
1 pointsWhich information does a switch use to keep the MAC address table information current?
Correct
Incorrect
-
Question 17 of 50
17. Question
1 pointsWhich advantage does the store-and-forward switching method have compared with the cut-through switching method?
Correct
Incorrect
-
Question 18 of 50
18. Question
1 pointsWhich characteristic describes cut-through switching?
Correct
Incorrect
-
Question 19 of 50
19. Question
1 pointsWhat is a result of connecting two or more switches together?
Correct
Incorrect
-
Question 20 of 50
20. Question
1 pointsIn what situation would a Layer 2 switch have an IP address configured?
Correct
Incorrect
-
Question 21 of 50
21. Question
3 pointsA network administrator is configuring a new Cisco switch for remote management access. Which three items must be configured on the switch for the task? (Choose three.)
Correct
Incorrect
-
Question 22 of 50
22. Question
1 pointsAs part of the new security policy, all switches on the network are configured to automatically learn MAC addresses for each port. All running configurations are saved at the start and close of every business day. A severe thunderstorm causes an extended power outage several hours after the close of business. When the switches are brought back online, the dynamically learned MAC addresses are retained. Which port security configuration enabled this?
Correct
Incorrect
-
Question 23 of 50
23. Question
1 pointsA network administrator is configuring port security on a Cisco switch. When a violation occurs, which violation mode that is configured on an interface will cause packets with an unknown source address to be dropped with no notification sent?
Correct
Incorrect
-
Question 24 of 50
24. Question
1 pointsWhich commands are used to re-enable a port that has been disabled as a result of a port security violation?
Correct
Incorrect
-
Question 25 of 50
25. Question
2 pointsWhich two characteristics describe the native VLAN? (Choose two.)
Correct
Incorrect
-
Question 26 of 50
26. Question
1 pointsWhich type of traffic is designed for a native VLAN?
Correct
Incorrect
-
Question 27 of 50
27. Question
1 pointsAn administrator is trying to remove configurations from a switch. After using the command erase startup-config and reloading the switch, the administrator finds that VLANs 10 and 100 still exist on the switch. Why were these VLANs not removed?
Correct
Incorrect
-
Question 28 of 50
28. Question
1 pointsRefer to the exhibit. Inter-VLAN communication between VLAN 10, VLAN 20, and VLAN 30 is not successful. What is the problem?
Correct
Incorrect
-
Question 29 of 50
29. Question
1 pointsA network administrator is configuring an ACL with the command access-list 10 permit 172.16.32.0 0.0.15.255. Which IPv4 address matches the ACE?
Correct
Incorrect
-
Question 30 of 50
30. Question
2 pointsThe computers used by the network administrators for a school are on the 10.7.0.0/27 network. Which two commands are needed at a minimum to apply an ACL that will ensure that only devices that are used by the network administrators will be allowed Telnet access to the routers? (Choose two.)
Correct 2 / 2PointsIncorrect / 2 Points -
Question 31 of 50
31. Question
1 pointsA network engineer has created a standard ACL to control SSH access to a router. Which command will apply the ACL to the VTY lines?
Correct
Incorrect
-
Question 32 of 50
32. Question
1 pointsWhich set of commands will configure a router as a DHCP server that will assign IPv4 addresses to the 192.168.100.0/23 LAN while reserving the first 10 and the last addresses for static assignment?
Correct
Incorrect
-
Question 33 of 50
33. Question
1 pointsRefer to the exhibit. R1 has been configured as shown. However, PC1 is not able to receive an IPv4 address. What is the problem?
Correct
Incorrect
-
Question 34 of 50
34. Question
1 pointsWhat is used in the EUI-64 process to create an IPv6 interface ID on an IPv6 enabled interface?
Correct
Incorrect
-
Question 35 of 50
35. Question
1 pointsRefer to the exhibit. Which statement shown in the output allows router R1 to respond to stateless DHCPv6 requests?
Correct
Incorrect
-
Question 36 of 50
36. Question
1 pointsRefer to the exhibit. NAT is configured on Remote and Main. The PC is sending a request to the web server. What IPv4 address is the source IP address in the packet between Main and the web server?
Correct
Incorrect
-
Question 37 of 50
37. Question
1 pointsWhich type of traffic would most likely have problems when passing through a NAT device?
Correct
Incorrect
-
Question 38 of 50
38. Question
1 pointsA small company has a web server in the office that is accessible from the Internet. The IP address 192.168.10.15 is assigned to the web server. The network administrator is configuring the router so that external clients can access the web server over the Internet. Which item is required in the NAT configuration?
Correct
Incorrect
-
Question 39 of 50
39. Question
1 pointsWhich configuration would be appropriate for a small business that has the public IP address of 209.165.200.225/30 assigned to the external interface on the router that connects to the Internet?
Correct
Incorrect
-
Question 40 of 50
40. Question
1 pointsWhat benefit does NAT64 provide?
Correct
Incorrect
-
Question 41 of 50
41. Question
1 pointsRefer to the exhibit. A PC at address 10.1.1.45 is unable to access the Internet. What is the most likely cause of the problem?
Correct
Incorrect
-
Question 42 of 50
42. Question
1 pointsA network engineer is interested in obtaining specific information relevant to the operation of both distribution and access layer Cisco devices. Which command provides common information relevant to both types of devices?
Correct
Incorrect
-
Question 43 of 50
43. Question
2 pointsWhich two statements are correct if a configured NTP master on a network cannot reach any clock with a lower stratum number? (Choose two.)
Correct
Incorrect
-
Question 44 of 50
44. Question
1 pointsA network administrator is verifying a configuration that involves network monitoring. What is the purpose of the global configuration command logging trap 4?
Correct
Incorrect
-
Question 45 of 50
45. Question
1 pointsRefer to the exhibit. An administrator is examining the message in a syslog server. What can be determined from the message?
Correct
Incorrect
-
Question 46 of 50
46. Question
1 pointsWhat is indicated by the M in the Cisco IOS image name c1900-universalk9-mz.SPA.153-3.M.bin?
Correct
Incorrect
-
Question 47 of 50
47. Question
1 pointsRefer to the exhibit. A network engineer is preparing to upgrade the IOS system image on a Cisco 2901 router. Based on the output shown, how much space is available for the new image?
Correct
Incorrect
-
Question 48 of 50
48. Question
1 pointsRefer to the exhibit. Based on the exhibited configuration and output, why is VLAN 99 missing?
Correct
Incorrect
-
Question 49 of 50
49. Question
4 pointsMatch the router memory type that provides the primary storage for the router feature. (Not all options are used.)
Sort elements
- flash
- ROM
- RAM
- NVRAM
-
full operating system
-
limited operating system
-
routing table
-
startup configuration file
Correct
Incorrect
-
Question 50 of 50
50. Question
4 pointsOrder the DHCP process steps. (Not all options are used.)
Sort elements
- step 3
- step 4
- step 2
- step 1
-
DHCPREQUEST (broadcast)
-
DHCPACK (unicast)
-
DHCPOFFER (unicast)
-
DHCPDISCOVER (broadcast)
Correct
Incorrect
Leaderboard: CCNA 2 v6.0 Final Exam B
Pos. | Name | Entered on | Points | Result |
---|---|---|---|---|
Table is loading | ||||
No data available | ||||