CCNA 3 v6.0 Scaling Networks SN Chapter 4 Exam Online
CCNA 3 v6.0 SN Chapter 4 Exam Training | |
---|---|
Time | 30 minutes |
Questions | 25 |
Leaderboard: CCNA 3 v6.0 Chapter 4 Exam
Pos. | Name | Entered on | Points | Result |
---|---|---|---|---|
Table is loading | ||||
No data available | ||||
CCNA 3 v6.0 Chapter 4 Exam
Time limit: 0
Quiz-summary
0 of 25 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
Information
CCNA 3 v6.0 Chapter 4 Exam
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 25 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
Your result has been entered into leaderboard
Loading
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- Answered
- Review
-
Question 1 of 25
1. Question
1 pointsRefer to the exhibit.
Which switching technology would allow each access layer switch link to be aggregated to provide more bandwidth between each Layer 2 switch and the Layer 3 switch?
Correct
Incorrect
-
Question 2 of 25
2. Question
1 pointsWhich statement is true regarding the use of PAgP to create EtherChannels?
Correct
Incorrect
-
Question 3 of 25
3. Question
2 pointsWhich two protocols are used to implement EtherChannel? (Choose two.)
Correct
Incorrect
-
Question 4 of 25
4. Question
1 pointsWhich statement describes a characteristic of EtherChannel?
Correct
Incorrect
-
Question 5 of 25
5. Question
1 pointsWhich statement describes an EtherChannel implementation?
Correct
Incorrect
-
Question 6 of 25
6. Question
1 pointsAn EtherChannel link using LACP was formed between two switches, S1 and S2. While verifying the configuration, which mode combination could be utilized on both switches?
Correct
Incorrect
-
Question 7 of 25
7. Question
1 pointsWhat is an advantage of using LACP?
Correct
Incorrect
-
Question 8 of 25
8. Question
1 pointsWhat is a best practice to use before beginning an EtherChannel implementation?
Correct
Incorrect
-
Question 9 of 25
9. Question
1 pointsWhich PAgP mode combination will establish an EtherChannel?
Correct
Incorrect
-
Question 10 of 25
10. Question
3 pointsWhich three options must match in order to establish an EtherChannel between two directly connected switches? (Choose three.)
Correct
Incorrect
-
Question 11 of 25
11. Question
1 pointsA network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode passive. Which command must be used on SW2 to enable this EtherChannel?
Correct
Incorrect
-
Question 12 of 25
12. Question
1 pointsRefer to the exhibit.
An EtherChannel was configured between switches S1 and S2, but the interfaces do not form an EtherChannel. What is the problem?
Correct
Incorrect
-
Question 13 of 25
13. Question
2 pointsRefer to the exhibit.
A network administrator has decided that an EtherChannel between ports 0/1 and 0/2 on switches S1 and S2 would help performance. After making the configuration, the administrator notices no performance gain. Based on the output that is shown, what two possible assumptions could a network administrator make? (Choose two.)
Correct
Incorrect
-
Question 14 of 25
14. Question
1 pointsRefer to the exhibit.
A network administrator issued the show etherchannel summary command on the switch S1. What conclusion can be drawn?
Correct
Incorrect
-
Question 15 of 25
15. Question
1 pointsRefer to the exhibit.
Correct
Incorrect
-
Question 16 of 25
16. Question
1 pointsWhat is a requirement to configure a trunking EtherChannel between two switches?
Correct
Incorrect
-
Question 17 of 25
17. Question
1 pointsWhat is the purpose of HSRP?
Correct
Incorrect
-
Question 18 of 25
18. Question
1 pointsWhich nonproprietary protocol provides router redundancy for a group of routers which support IPv4 LANs?
Correct
Incorrect
-
Question 19 of 25
19. Question
1 pointsRefer to the exhibit.
A network administrator configured routers R1 and R2 as part of HSRP group 1. After the routers have been reloaded, a user on Host1 complained of lack of connectivity to the Internet The network administrator issued the show standby brief command on both routers to verify the HSRP operations. In addition, the administrator observed the ARP table on Host1. Which entry should be seen in the ARP table on Host1 in order to gain connectivity to the Internet?
Correct
Incorrect
-
Question 20 of 25
20. Question
1 pointsRefer to the exhibit.
What statement is true about the output of the show standby command?
Correct
Incorrect
-
Question 21 of 25
21. Question
1 pointsRefer to the exhibit.
A network engineer is troubleshooting host connectivity on a LAN that uses a first hop redundancy protocol. Which IPv4 gateway address should be configured on the host?
Correct
Incorrect
-
Question 22 of 25
22. Question
1 pointsA network administrator would like to ensure that router R1 is always elected the active router for an HSRP group. Which set of commands would ensure the required results?
Correct
Incorrect
-
Question 23 of 25
23. Question
1 pointsFill in the blank.
- In FHRP operation, two or more routers are represented as a single (virtual, VIRTUAL) router.
Correct
Incorrect
-
Question 24 of 25
24. Question
4 pointsMatch the description to the correct command. (Not all options are used.)
Sort elements
- This command shows information about the status of a port that is involved in the Etherchannel.
- This command shows information about the reability of the port channel.
- This command is used to check what port channels are configured on a switch.
- This command shows the list of ports that are involved in the port channel and the time since the ports were bundled.
-
show interfaces fa0/2 etherchannel
-
show interfaces port-channel1
-
show etherchannel summary
-
show etherchannel port-channel
Correct
Incorrect
-
Question 25 of 25
25. Question
2 pointsOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question.
What are two reasons why the ping messages that are issued from Laptop0 towards Laptop1 are failing? (Choose two.)
Correct
Incorrect