CCNA 3 v6.0 Scaling Networks SN Chapter 6 Exam Online
CCNA 3 v6.0 SN Chapter 6 Exam Training | |
---|---|
Time | 30 minutes |
Questions | 25 |
Leaderboard: CCNA 3 v6.0 Chapter 6 Exam
Pos. | Name | Entered on | Points | Result |
---|---|---|---|---|
Table is loading | ||||
No data available | ||||
CCNA 3 v6.0 Chapter 6 Exam
Time limit: 0
Quiz-summary
0 of 25 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
Information
CCNA 3 v6.0 Chapter 6 Exam
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 25 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
Your result has been entered into leaderboard
Loading
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- Answered
- Review
-
Question 1 of 25
1. Question
1 pointsWhen an EIGRP-enabled router uses a password to accept routes from other EIGRP-enabled routers, which mechanism is used?
Correct
Incorrect
-
Question 2 of 25
2. Question
1 pointsWhat is the purpose of using protocol-dependent modules in EIGRP?
Correct
Incorrect
-
Question 3 of 25
3. Question
1 pointsIf all router Ethernet interfaces in an EIGRP network are configured with the default EIGRP timers, how long will a router wait by default to receive an EIGRP packet from its neighbor before declaring the neighbor unreachable?
Correct
Incorrect
-
Question 4 of 25
4. Question
1 pointsWhich statement describes a characteristic of the delivery of EIGRP update packets?
Correct
Incorrect
-
Question 5 of 25
5. Question
2 pointsWhich two EIGRP packet types are sent with unreliable delivery? (Choose two.)
Correct
Incorrect
-
Question 6 of 25
6. Question
1 pointsWhich destination MAC address is used when a multicast EIGRP packet is encapsulated into an Ethernet frame?
Correct
Incorrect
-
Question 7 of 25
7. Question
1 pointsWhat is identified within the opcode of an EIGRP packet header?
Correct
Incorrect
-
Question 8 of 25
8. Question
1 pointsAn administrator issues the router eigrp 100 command on a router. What is the number 100 used for?
Correct
Incorrect
-
Question 9 of 25
9. Question
1 pointsWhy would a network administrator use a wildcard mask in the network command when configuring a router to use EIGRP?
Correct
Incorrect
-
Question 10 of 25
10. Question
1 pointsWhat information does EIGRP maintain within the routing table?
Correct
Incorrect
-
Question 11 of 25
11. Question
1 pointsWhich table is used by EIGRP to store all routes that are learned from EIGRP neighbors?
Correct
Incorrect
-
Question 12 of 25
12. Question
1 pointsWhich command or commands must be entered on a serial interface of a Cisco router to restore the bandwidth to the default value of that specific router interface?
Correct
Incorrect
-
Question 13 of 25
13. Question
3 pointsWhich three metric weights are set to zero by default when costs in EIGRP are being calculated? (Choose three.)
Correct
Incorrect
-
Question 14 of 25
14. Question
2 pointsA new network administrator has been asked to verify the metrics that are used by EIGRP on a Cisco device. Which two EIGRP metrics are measured by using static values on a Cisco device? (Choose two.)
Correct
Incorrect
-
Question 15 of 25
15. Question
2 pointsRefer to the exhibit.
Which two networks contain feasible successors? (Choose two.)
Correct
Incorrect
-
Question 16 of 25
16. Question
1 pointsA network administrator wants to verify the default delay values for the interfaces on an EIGRP-enabled router. Which command will display these values?
Correct
Incorrect
-
Question 17 of 25
17. Question
1 pointsRefer to the exhibit.
R3 has two possible paths to the 172.16.99.0 network. What is the reported distance of the feasible successor route?
Correct
Incorrect
-
Question 18 of 25
18. Question
1 pointsRefer to the exhibit.
R2 has two possible paths to the 192.168.10.4 network. What would make the alternate route meet the feasibility condition?
Correct
Incorrect
-
Question 19 of 25
19. Question
2 pointsWhich two factors does an EIGRP router use to determine that a route to a remote network meets the feasible condition and is therefore loop-free? (Choose two.)
Correct
Incorrect
-
Question 20 of 25
20. Question
1 pointsWhich configuration is necessary to ensure successful operation of EIGRP for IPv6?
Correct
Incorrect
-
Question 21 of 25
21. Question
1 pointsFill in the Blank. Use the abbreviation.
- EIGRP uses the protocol (RTP, rtp) to deliver EIGRP packets to neighbors.
Correct
Incorrect
-
Question 22 of 25
22. Question
1 pointsFill in the blank.
- In an EIGRP topology table, a route that is in a/an (active, ACTIVE) state will cause the Diffusing Update Algorithm to send EIGRP queries that ask other routers for a path to this network.
Correct
Incorrect
-
Question 23 of 25
23. Question
3 pointsOrder the precedence in which an EIGRP router would choose the router ID. (Not all options are used.)
Sort elements
- first
- third
- second
-
eigrp router-id command
-
highest IPv4 address on active physical interfaces
-
highest IPv4 address on loopback interfaces
Correct
Incorrect
-
Question 24 of 25
24. Question
3 pointsMatch the correct version of EIGRP with the EIGRP features. (Not all options are used.)
Sort elements
- EIGRP for IPv4 only
- both EIGRP for IPv4 and EIGRP for IPv6
- EIGRP for IPv6 only
-
source address for EIGRP messages is a routable address
-
uses a 32-bit router ID
-
source address for EIGRP messages is a link-local address
Correct
Incorrect
-
Question 25 of 25
25. Question
1 pointsOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question.
Which code is displayed on the web server?
Correct
Incorrect